HERO GEAR specialises in GoPro HERO camera accessories
All Australian Stock and Warranty - Free Standard postage Australia Wide included in the Price
If you need it urgently, please consider using an EXPRESS Post option.
Zhiyun Z1-Evolution 3-Axis Gimbal for GoPro HERO3/3+/4/Session with 4 Way Joystick
The Zhiyun Z1-Evolution 3-Axis Handheld Gimbal with 4 Way Joystick is truly something special!
You will be able to create incredibly smooth footage with your GoPro HERO camera attached to the Evolution gimbal.
It is compatible with GoPro HERO3, GoPro HERO3+, GoPro HERO4 and GoPro HERO4 Session cameras (Note: an additional bracket is required for GoPro HERO4 Session and HERO5 Session cameras (sold separately).
The Hand Grip has a built-in 4 way stepless rotational Joystick makes adjusting the camera angle incredibly easy.
The motors don't produce any audible noise, so the camera mic won't pick up the movement of the motors. You can control the pitch, roll and pan through automated settings or manual controls.
The rotation angle of each motor is up to 330 degrees.
The unit also offers a 3.5mm headphone jack that outputs audio and video.
The Power switch is located on the side of the handle. Built-in reverse polarity protection, over charging protection, and short circuit protection makes it remarkably power efficient. The 1/4inch screw port on the bottom allows for easy attachment to most extension rods currently on the market, or even a standard Quarter-20 Tripod.
The integrated camera holder allows for mounting the GoPro HERO camera and BacPac without changing screws.
Two IMR 18650 (2000mAh) batteries are included and allow up to 12 Hours operation.
GoPro camera can be charged directly from the Gimbal batteries by plugging in one of the camera charging cables. Gimbal batteries need to be charged externally in the Battery charging cradle. Extra batteries can be purchased separately.
1x Evolution Gimbal
1x Video output/Charging cable
1x Camera Charging cable
1x Battery Extension Tube
2x IMR 18650 2000mAh batteries
1x Twin Charging cradle
1x Micro USB cable
1x Camera protection sticker for pan motor
This product has an electronic Gyroscope inside. It may be influenced by changes in temperature. If so, you may need to calibrate the gimbal before use. Instructions and tools for calibration can be obtained by going to the ZhiYun-tech website.
However, once calibrated, new Automatic Drifting Suppression means the need to Re-Calibrate is greatly reduced.
Note: GoPro Cameras are NOT included. They are shown for demonstration purposes ONLY.
Compatible with the following GoPro HERO Camera Models:
GoPro HERO4 Session (* requires an additional mounting bracket - not included)
GoPro HERO5 Session (* requires an additional mounting bracket - not included)